Motorola HC05 HC08 QFP64 Adapter for ETL XPROG-M Programmer

This Motorola HC05 HC08 QFP64 Adapter is a hardware accessory designed to work with ETL and XPROG-M (XPROG-Box) programmers for reading and writing microcontrollers.


Key Features

• Compatibility: Support Motorola / Freescale MC68HC05, MC68HC08, MC908AZ60, MC705X32 chips in QFP64 / TQFP64 package
• Programmer Support: Directly compatible with XPROG-M and ETL chip programmers
• Socket Type: ZIF (Zero Insertion Force) hinged cover socket

- ZIF hinged cover design, zero insertion force. Open the lid to place chip easily, close to lock pins evenly. Avoid bent fragile IC leads, stable contact for read/write.
- Built-in alignment frame, help correct PIN1 orientation, reduce wrong placement risk.
- Protect internal spring contacts from flux and solder dust, extend service life.


Common Applications

• Automotive ECU programming, flash & EEPROM reading and writing
• Mercedes-Benz EZS (Electronic Ignition Switch) module service & repair
• Key learning, immobilizer data recovery, dashboard repair and mileage correction


Important Warning

-- This is ZIF socket version. You need to desolder the chip from PCB first. It is NOT an on-board no-solder probe adapter.
-- Same QFP64 ZIF hinged appearance does NOT mean universal for all programmers.
-- This adapter’s PCB wiring, pin mapping and peripheral circuits are specially designed for ETL / XPROG-M / XPROG-Box, for Motorola HC05 HC08 series chips.
-- It will NOT work directly with UPA, Orange5, R270, Tango or other programmers. Mismatched pinout may cause communication failure or damage the chip/programmer.
-- Poor pin condition, corroded or bent chip pins may lead to read/write failure.